Installation Manual

TROUBLESHOOTING GUIDE (CONTINUED)
IR Remote Control
Remote control does not work on either monitor.
1. Check that the battery is good.
2. Check that the battery is installed properly.
3. To control the M1 monitor, make sure M1 is pressed and the DVD button is
pressed for DVD controls. For system controls, press the M1 button and the
TV button.
4. Test the remote control with a cell phone. Turn on the cell phone camera. Press
and hold a button on the remote control while pointing the remote control at the
cell phone’s camera. If the remote control is working, a blue ickering light will
appear on the screen.
5. Unplug the BLUE DIN cable from the FMM Interface Box and retest the remote
control on the M1 monitor. If the remote control works, there is a problem with
the M2 monitor or BLUE DIN cable.
6. Plug the BLUE DIN cable back into the FMM Interface Box. Unplug the GREEN
DIN cable from the FMM Interface Box and retest the remote control on the M2
monitor. Make sure that the M2 button is pressed on the remote control. If the
remote control works, there is a problem with the M1 monitor or the GREEN
DIN cable.
TROUBLESHOOTING GUIDE (CONTINUED)
M1 DIN cables and M2 DIN cables can be swapped for troubleshooting:
Plug the M2 - Blue to M1 - Green connector on the box Plug the M2 - Yellow to
M1 - Pink connector on the box Plug the M1 - Green to M2 - Blue connector on
the box Plug the M2 - Pink to M2 - Yellow connector on the box
This changes the M1 monitor to the M2 monitor and the M2 monitor to the M1
monitor. The (new) M1 monitor can be used to control the wireless FM modulator.
DIN CABLE WIRING FOR M1 and M2 MONITORS