Custom Vehicle Headrests with 7” or 8” Slim Style LED LCD Monitors with Built-in DVD Player for Rear Seat Entertainment 8” Slim Style LED LCD Monitor 7” Slim Style LED LCD Monitor Installation Guide
IMPORTANT NOTICE Installation of headrest products require careful planning and preparation. Be extremely careful of seats that have airbags built into them. Keep wiring away from any airbag wiring (usually identified by yellow connectors and yellow wire jackets). Damage to airbag wiring can result in personal injury to vehicle occupants. If you have any questions regarding wire routing or installation in a vehicle, please contact VOXX Technical Support at 1-800-225-6074.
VEHICLE PREPARATION (continued): VEHICLE PREPARATION: 1) Read the installation guide and get familiar with the electrical requirements and connections. 6) Connect all the components together (electrically) and verify proper operation of all the system functions. (Refer to the Headrest System Wiring Diagram on page 6) 2) Prepare the vehicle by removing any interior trim necessary to gain access to the vehicle’s wiring as well as all areas where interconnecting wire harnesses will be located.
HEADREST SYSTEM WIRING DIAGRAM 7“ ELECTRONICS INSTALLATION/REPLACEMENT GUIDE Install Monitor Unit To Headrest Master Monitor Satellite Monitor Installation NOTE: Switch off the ACC power during cable and unit installation. Failure to do so may damage the unit. 2 1 a a Connect to external source such as Blu-ray player, game console or multi-media head unit output.
7“ ELECTRONICS INSTALLATION/REPLACEMENT GUIDE (continued) 8“ ELECTRONICS INSTALLATION/REPLACEMENT GUIDE Install Monitor Unit To Headrest 6 5 Installation Reverse the procedure for removing the electronics. NOTE: Switch off the ACC power during cable and unit installation. Failure to do so may damage the unit.
8“ ELECTRONICS INSTALLATION/REPLACEMENT GUIDE (continued) 6 5 OPTIONAL: he MVGP1 Game Package is the optional accessory package that allows adding T a wireless game source feature. MVGP1 Game Module Package (P/N MVGP1) The Game Module Package contains the following items: a) Game Controller P1 c) Game Module (P/N 136-5320) - (1pc) (P/N 136-5319) - (1pc) P1 Reverse the procedure for removing the electronics.
Troubleshooting Guide Troubleshooting Guide (continued) AUDIO RELATED ISSUES No audio on the M2 monitor when playing a DVD on the M1 monitor. No audio on wireless headphones while playing a DVD 1. Check to see if there is audio on the RCA output connectors of the FMM interface box (the FM modulator uses the same audio for the AV output of the FMM Interface Box). 1. Check that the batteries in wireless headphones are good and that they are installed properly. 2.
Troubleshooting Guide (continued) Troubleshooting Guide (continued) IR Remote Control M1 DIN cables and M2 DIN cables can be swapped for troubleshooting: Remote control does not work on either monitor. Plug the M2 - Blue to M1 - Green connector on the box Plug the M2 - Yellow to M1 - Pink connector on the box Plug the M1 - Green to M2 - Blue connector on the box Plug the M2 - Pink to M2 - Yellow connector on the box 1. Check that the battery is good. 2. Check that the battery is installed properly. 3.
www.voxxelectronics.com If you have any questions regarding this product or require technical assistance, please call 1-800-225-6074. © 2014 VOXX Electronics Corp.
