Installation guide

ADV48

1) Make the connections to the vehicle for the 12 pin wiring harness.

2) Connect power harness to vehicle’s electrical system by tapping into an accessory hot

line and a good ground.

3) Connect the 12 pin harness to the mating connector on the Video Monitor.

4) If an auxiliary video input is used (VCP, DVD, etc) insert the Circular Mini-Din

Connector of the source component harness through the wire tie loop on the main

PCB and into the Mini-Din Connector on the main PCB.

5) Pull the wire tie loop tight and cut off the excess.

Note: A VCP or other A/V Component can be connected to the video monitor system

using a source component harness (purchased separately, part number: 8010730).

This harness plugs into the Mini-Din connector on the main PCB as in steps 4 and 5

above.(See Figure A on next page)

6) Verify all functions of the System before final mounting of the finished assembly.

7) Mount and connect the Television antenna. (Optional)

*NOTE: If the optional relay box P/N SIRSWB is installed, it recommended that the

antenna for the wireless FM Modulator be unplugged. See ADV48 Wiring

Diagram (Figure A) for antenna location.

**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM

Modulator to exceed FCC limits for wireless transmission. When installing the

unit position the antenna for best reception.

A/V Source Definitions:

1. DVD – Built in DVD

2. Video 1 - DIN Cable (Optional) P/N 8010730

3. Video 2 - RCA Jack pigtail ( Internal)

4. Video 3 - External “Smart Port” connection for AUX cable or Optional iPod cable.