Owner’s Manual
Blind Spot and Cross-Traffic Detection System
User Guide & Warranty
WARNING: To help avoid injuries, never use the Blind Spot Detection System as a replacement for
checking the interior and exterior mirrors and looking over your shoulder before changing lanes.
The Blind Spot Detection System is not a replacement for careful driving.
Event Turn Signal System Action
No vehicle in Blind Spot Off NA
Vehicle in Blind Spot Off
LED On – Solid
Buzzer Off (if installed)
Vehicle in Blind Spot On
LED On - Rapid Flash
Buzzer On (if installed)
False Alerts:
It is possible that the Blind Spot Detection System will trigger an alert even though there is no vehicle in the
blind spot zone. If your vehicle is towing a trailer, the sensors could possibly detect the trailer and trigger the
Blind Spot Detection System. The Blind Spot Detection System can detect objects such as; construction barrels,
guard rails, lamp posts, etc. Occasional false alerts are normal.
System limitations:
The Blind Spot Detection System does have limitations. Conditions such as severe weather or debris buildup on
the sensor areas may limit vehicle detection.
Other situations that may limit Blind Spot Detection System include:
• Certain maneuvers of other vehicles as they enter and exit the blind spot zone.
• Vehicles passing through the blind spot zone at very fast rates.
• Several vehicles forming a convoy and passing through the blind spot zone.
Using your BSD:
The Blind Spot Detection System will turn on when you start the engine and begin driving forward above
approximately 20 mph (installer can adjust this threshold).
Overview:
The Blind Spot Detection System (BSD) is designed to aid in detecting vehicles that may have entered the blind
spot zone, which is represented by the vehicles in positions 1 & 2 of the diagram below. The detection area is
on both sides of your vehicle, extending rearward from the exterior mirrors to approximately 30 feet beyond
the bumper. The system is designed to alert you if vehicles, approaching from the rear, enter the blind spot
zone.
Using Cross-Traffic Detection:
When in reverse, the system will detect vehicles approaching from the left and right. The buzzer will sound and
the LED light will Illuminate to indicate an approaching vehicle.