SDS

Material Safety Data Sheet
Report No.: TCT191227M145 Page 5 of 8
Hotline: [phone] Tel: [phone] Fax: [phone] http://www.tct-lab.com
Section 8 - Exposure Controls/Personal Protection
Engineering Controls
Use adequate ventilation to keep airborne
concentrations low. If used under conditions that
generate particulates, the ACGIH TLV-TWA of
3mg/m
3
respirable fraction (10mg/m
3
total) should be
observed.
Personal Protective Equipment
Eye and Face Protection: None required for
consumer use. If there is a Hazard of contact: Tight
sealing safety goggles. Face protection shield.
Skin and Body Protection: None required for
consumer use. If there is a Hazard of contact: Wear
protective gloves and protective clothing.
Respiratory Protection: No protective equipment is
needed under normal use conditions. If exposure
limits are exceeded or irritation is experienced,
ventilation and evacuation may be required.
Section 9- Physical and Chemical Properties
Physical State
Appearance: Prismatic
Color: Silver
Odour: If leaking, smells of medical ether.
Change in condition
pH
Not applicable as supplied.
Flash Point
Not applicable unless individual components exposed.
Flammability
Not applicable unless individual components exposed.
Relative density:
Not applicable unless individual components exposed.
Solubility (water)
Not applicable unless individual components exposed.
Solubility (other)
Not applicable unless individual components exposed.
Section 10 – Stability and Reactivity
Chemical Stability
Stable under recommended storage conditions.
Possibility of Hazardous Reactions
None under normal processing.
Conditions to Avoid
Exposure to air or moisture over prolonged periods.