User Guide

6101 Lake Ellenor Drive • Orlando, Florida 32809
Tel: 800/ADVANTOR • 407/859.3350 • Fax: 407/859.5205
http://www.advantor.com
Specifications and part numbers are subject to change without notice.
Expansion Module
The Expansion Module provides the Advantage
®
plus Base Module with an
additional 16 supervised, programmable alarm points, and four additional auxiliary
outputs. Each Base Module can interface and control up to 8 Expansion Modules.
Dimensions
PCB Foot Print
6.87" W x 4.125" H (17.45cm x 10.48cm)
Alarm Points
16 programmable, supervised, hard-wired points
N/C, N/O, or Both (Dry Contact)
Programmable alarm codes
Programmable into any of 8 separate arming
partitions(protected areas)
All alarm points operate normally under ground fault
conditions
Operating Environment
0° F to 122° F (-18° C to 50° C)
Auxiliary Outputs
Four, 100mA, programmable hard-wired
Power Requirements
12 VDC (from Base Module or optional APS12V1A-S
Advantage PowerSource)
130mA maximum in both Normal Standby and Alarm
Part Numbers
ADV LEM Loop Expansion Module with
Installation Kit
APS12V1A-S Power Supply, 12VDC
90226101 PCB, Expansion Module
90237200 Standard Enclosure with Lock
and Key
AVR CHAS/SUR115 Standard Enclosure, Internal
Transformer (120VAC) and AC
“Level 2” surge protection
AVR CHAS/SUR220 Standard Enclosure, Internal
Transformer (220VAC) and AC
“Level 2” surge protection
Communications
Base Module RS-485 Communication link up to 2,000
feet maximum with 22AWG shielded twisted pair
cable
Mounting
One mounts locally inside Base Module enclosure or
remotely inside an optional enclosure up to 2,000 feet
from the Base Module
40003401 Enclosure Tamper Switch
90258200 Attack Enclosure with Lock and
Key
08610416 Transformer, 16.5VAC, 50VA,
Plug-In
09820453 Loop Expansion Module
Installation Instructions
08061699 AC Surge Protector (120VAC),
hardwired
08061431 AC Surge Protector (220VAC),
hardwired
08061206 Battery, 12V, 7AH Gel Cell
P/N 09820483, Rev. A
6/98