24 Port Fast Ethernet With 2 Port Gigabit Switching Hub User’s Manual Model # ANS-2402G 1
FCC Warning This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules. These limitations are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents 1 Introduction to the Switching Hub …………………………………………………... 4 1.1 General Description ………………………………………………………………………..4 1.2 Features …………………………………………………………………………………….4 1.3 The Front Panel ……………………………………………………………………………4 1.4 Uplink Port ………………………………………………………………………………….5 1.5 The Rear Panel …………………………………………………………………………….5 1.6 What items come with package …………………………………………………………..5 2 Installing and using the Switching Hub ……………………………………………...5 2.
Learning ……………………………………………………….6 3.2 Filtering and Forwarding …………………………………………………………………..6 3.3 Store and Forward …………………………………………………………………………7 4. Product Specification ………………………………………………………………….8 1 Introduction to the Switching Hub 1.1 General Description This device is a high-performance 24 port Fast Ethernet with 2 port Gigabit Ethernet switching hub capable of 10, 100 and 1000Mbps auto-negotiation operation.
1.3 The Front Panel Functional LED Description LED PWR BK 1….24 25, 26 Link/Act 10M 100M 1000M Description When Gigabit switching hub connects to power, this LED will be on. When Broadcast Storm occurs, this LED will blink. Fast Ethernet Port LED numbers. Gigabit Port LED numbers. Link is established (green), Transferring data (blinking green), No connection (off) When data transferring rate is 10Mbps, this LED will blink, otherwise LED is off.
is ready. 2.2 Installing The hub does not require install device driver. Users can immediately use any of the features of this product simply by attaching the cables and connecting the power, then turn on the switch. 2.2.1 Desktop Installation To locate the switching hub on the desktop and place the hub on a clean, flat desk or table close to a power outlet. Plug in all network connections and the power cable, then the system is ready 2.2.
The switching hub is implemented with a MAC address table which is composed of many entries. Each entry is used to store the address information of network nodes on the network, including MAC address, port ID, etc. The information is the most important base to do packet filtering and forwarding. When one packet comes in from any port, the switching hub will learn the source address, port ID, and the other related information in address table.
Keep Ethernet cables away from sources of electrical noise such as radios, transmitters, broadband amplifiers, power lines and fluorescent lighting fixtures. Water or moisture can not enter the unit Air flow around the unit and through the vents in the side of the case is not restricted Never stack units more than eight high if freestanding Do not place objects on top of any unit of stack Do not obstruct any vents at the sides of the cases 4. Product Specifications Standard IEEE802.3, 10BASE-T IEEE802.
Port x 2, 10M, 100M, 1000M, Link, Activity Filtering / warding Rate : 10Mbps : 14,880pps / 14,880pps 100Mbps : 148,800pps / 148,800pps 1000Mbps: 1,488,000pps / 1,488,000pps Operating Temperature 0-45 C (32-113 F) Operating Humidity 10% - 90% Power Supply AC(100~240) 50/60Hz Internal Switch Power 9
