User manual

UTC-520 User Manual 12
3.1 Introduction
The UTC-520 consists of a PC-based computer that is housed in a Aluminum extru-
sion. You can install a HDD, DRAM, and Compact Flash by removing the rear cover.
Any maintenance or hardware upgrades can be easily completed after removing the
rear cover.
3.2 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one Serial Advanced Technology Attachment (SATA) hard disk drive
to the UTC-520's internal controller. TheSATA controller supports faster data transfer
and allows the SATA hard drive to exceed 150MB. The following are instructions for
installation:
1. Detach and remove the rear cover.
2. Place the HDD in the metal bracket, and tighten the screws (see Figure 3.1).
3. The HDD cable (SATA 7P+1*5P-2.5/SATA(15+7)P) is next to the metal brace.
Connect the HDD cable to the motherboard (CN3/CN5). Plug the other end of
the cable into the SATA hard drive.
4. Put the rear cover on and tighten the screws.
Warning! Do not remove the rear cover until you have verified that no power is
flowing within the UTC-520. Power must be switched off and the power
cord must be unplugged. Every time you service the UTC-520, you
should be aware of this.