User manual

UTC-515/520/532 User Manual 22
3.1 Introduction
UTC consists of a PC-based computer that is housed in an Aluminum extrusion. You
can install a HDD, DRAM, and Compact Flash (A/B platform only) by removing the
rear cover. Any maintenance or hardware upgrades can be easily completed after
removing the rear cover.
3.2 Installing the 2.5” Storage
UTC reserved a 2.5” SATA Storage Bay for customization. Please refer below figures
illustration for reference
1. Detach and remove the rear cover.
2. Place the Storage in the metal bracket, and tighten the screws
3. Connect SATA signal and power cable to MB and HDD/SSD
4. Put the rear cover on and tighten the screws.
Warning! Do not remove the rear cover until you have verified that no power is
flowing within the UTC. Power must be switched off and the power cord
must be unplugged.