User manual

31 UNO-4673A/4683 Series User Manual

Appendix A System Settings & Pin Assignments

A.5 VGA Display Connector (UNO-4673A series)

A.6 SATA Hard Drive RAID Support (UNO-4683

Series)

In order to install an operating system onto a RAID volume, the RAID option must be

enabled in the system BIOS, a RAID volume must be created, and the F6 installation

method must be used to load the Intel Rapid Storage Technology driver during oper-

ating system setup.

Before you start, please make sure that two SATA hard drives have been mounted in

system. A USB floppy will be also required for some additional files.

A.6.1 Enable RAID in System BIOS

Use the instructions included with your motherboard to enable RAID in the system

BIOS.

1. Click Del to enter the BIOS Setup program after the Power-On-Self-Test (POST)

memory test begins.

2. Click the Integrated Peripherals menu.

3. Click the OnChip IED Device menu.

4. Switch the SATA Mode option to RAID to enable Intel® RAID Technology.

5. Click F10 to save the BIOS settings and exit the BIOS Setup program.

Table A.7: VGA Adaptor Cable Pin Assignments

Pin Signal Name

1 Red

2 Green

3 Blue

4 NC

5 GND

6 GND

7 GND

8 GND

9 NC

10 GND

11 NC

12 NC

13 H-SYNC

14 V-SYNC

15 NC

10 6