User manual
37 Chapter 3
3.3 Installing a Hard Disk
The procedure for installing
a hard disk into the UNO-3072L is listed
below. Please
follow these steps
carefully.
1.
Remove the
power cord.
2.
Unscrew the two
screws
from the upper HDD
cover
3.
Unscrew the four
screws from the upper cover and remove it.
4.
Install
the
HDD in HDD bracket and secure with the four screws.
5.
Connect
the IDE flat
cable to
Primary (recommended; CN1
of main-
board)
or secondary IDE
connector (CN2 of mainboard), then con-
nect the other side of
the connector to
the hard
disk.
(Figure 3.1)
6.
Screw
on the upper cover
with the
four
screws.
Figure 3.1:
Location of IDE Connector (CN1 and CN2)
3.4 Installing a PCI-bus Card
The procedure for installing a PCI-bus card into the UNO-3072L is listed
below. Please
follow these steps
carefully.
1.
Remove the
power cord.
2
.Remove
the upper cover
of UNO-3072L.
3. Unscrew the screw of a PCI bracket, and remove it.
4.
Plug-in PCI-bus
card in
a PCI-slot of
UNO-3072L.
5.
Screw
the 1st anti-vibration
rubber
towards
the 1st PCI
card until it
is
fixed.
(Figure
3.2).