User manual

UNO-3072L User Manual 36
Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
UNO-3072L has one internal CompactFlash slot (CN3). It's used to
install O.S and Application Program
JP2 on mainboard (refer to Figures A.4 and A.5)
Closed: CN3 CompactFlash on mainboard is the master
Open:
CN3 CompactFlash on mainboard is slave
NOTE: 1. Only one CompactFlash can be set as master
2. Internal & external CompactFlash doesn't support Hot Swap
3. Needs to use " Fixed Disk Mode" CompactFlash to install OS
Following is the procedure for the installing a CompactFlash card in the
internal slot (CN3) of your UNO-3072L. Please follow these steps
carefully:
1. Remove the power cord .
2 . Unscrew the four screws from the top cover of U NO-3072L.
3. Remove the top cover .
4. Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot
on mainboard .
5. Screw back the top cover with four screws .
3.2 Connecting Power
Connect the UNO-3072L to a 16 ~ 36 VDC power source. The power
source can either be from a power adapter or an in-house
power source.