User manual

UNO-1110 User Manual 12
2.7 Simulation DI
UNO-1110 provides four simulation DI lines via DIP switch setting located on the top
side of UNO-1110.
Simulation DI is user-friendly design for users to setup different system parameters /
configuration according to DIP switch setting.
2.8 USB Connector
The USB interface supports Plug and Play, which enables you to connect or discon-
nect a device whenever you want, without turning off the computer.
The UNO-1110 provides four connectors of USB interfaces, which gives complete
Plug & Play and hot swapping for up to 127 external devices. The USB interface
complies with USB EHCI, Rev. 2.0 compliant.
2.9 VGA
The UNO-1110 provides a VGA 16bit converter (THS8136) for a high resolution VGA
interface. CRT Mode: 1024 x 768 @ 60Hz, 800 x 600 @ 60Hz, 640 x 480 @ 60Hz.
Table 2.7: Simulation DI Setting
DIP Switch Logic
ON 0
OFF 1
Note! If use high power USB device, it is better plug-in device before system
turn-ON.
Table 2.8: USB Connector Pin Assignments
Pin Signal Name Cable Color
1 VCC Red
2DATA- White
3 DATA+ Green
4GND Black
Table 2.9: VGA Adaptor Cable Pin Assignments
Pin Signal Name Pin Signal Name
1RED 9NC
2 GREEN 10 GND
3BLUE 11NC
4NC 12NC
5 GND 13 H-SYNC
6 GND 14 V-SYNC
7 GND 15 NC
8GND