User`s manual

60 TPC-1260 User's Manual
E.2 Install Operating System on the
TPC-1560
After properly docking of the HDD module as described in previous
section, the TPC-1560 is ready for installing operating system like
Microsoft Windows now. There are an adapter board and a piece of
IDE cable:
Step 1: Make sure the system is still powered off after HDD module
installation.
Step 2: Insert the adapter board into the CompactFlash slot on the side
of the TPC-1560.
Step 3: Connect the 44-40-40 pins IDE cable to the connector on the
adapter board.
Step 11: Unlock the HDD lock switch. Move it to the right then the
lock is released. Slide the whole HDD module into the opening on the
TPC-1560. Note that the insulator (i.e. the PCBA side) should be
toward users. As the HDD module dock on position move the HDD
lock switch to the left. Fasten the lock switch screw to secure lock if
necessary.
3. Dismounting HDD: reversing the procedure of assembling HDD,
Step 1: Unlock the HDD module, and take out the whole HDD module.
Step 2: Remove the four bracket screws.
Step 3: Remove the two interface board screws to release the reinforce-
ment plate of the IDE adapter board. Take away the plastic case.
Step 4: Flip the HDD module, and take away the HDD bracket.
Step 5: Remove the four rubber feet.
Step 6: Remove the HDD insulator, then the HDD is available for
maintenance or contents updating.