Specifications

SSBP-3000C
Page 32
sub-menu. Press the [Enter] key a second time to switch between the two sub-menus. Press
the [CLEAR] key to return to the ‘System Control’ menu.
NOTE: When the ‘OFF’ function is selected, the Mute LED on the front panel will
illuminate and the RF output signal will disappear. If the ‘ON’ function is selected,
the Mute LED will extinguish and the RF signal will appear at the RF output port
(J7).
7.5 DOWNLOADING THE SUPPLIED SOFTWARE
If it is required to change the internal software features, then download the information provided
by the supplied software as follows:
1. If using either the RS-232 or the RS-485 interface, set up the serial communication linkage
between the SSPB and the user’s computer terminal. See Section 5.3.3 at page 27.
2. At the PC, create a new folder”.
3. From the supplied source, copy the file named “DLAPP1.exe” and the file with extension
“hex” into the folder.
4. At the front panel of the SSPB, use the [é] and [ê] keys to select the ‘Enter for Download’
menu and then press and hold the [Enter] key.
NOTES: Pressing the [Enter] key temporarily will cause the transmitter unit to restart.
After several seconds, the message “Ready for Download” appears on the display.
5. At the PC, open the new folder and click on the file “DLAPP1.exe”.
6. At the prompt type “s[space]comX” and then press [Enter].
NOTE: X is the number of the communication port connected to the unit.
7. At the prompt type “l[space] filename.hex” and then press [Enter].
8. Wait for 2 minutes.
Live data will appear on the screen for the duration.
9. Once loading is complete, close the application.