Specifications

SSBP-3000C
Page 28
d. Connect the AC power cable to AC Line port of the SSPB and the AC power source.
TABLE 9: POWER REQUIREMENTS
Power Requirements 180 - 264 VAC, 47-63 Hz, single phase
Power Consumption 8 A typical @ 230 VAC
TABLE 10: AC LINE (J5) CONNECTOR – PIN ASSIGNMENTS
Pin Description
A PHASE (LIVE)
B GROUND
C NEUTRAL
5.3.4 RF CONNECTIONS
1. Attach the interconnecting cable with a N-type male connector from the RF source on to the L-
Band IN connector (J1) located on the rear panel (see Figure 5 at page 24).
2. If necessary, connect a power meter or a spectral analyser to the RF output monitor port
located on the front panel (see Figure 5 at page 24).
CAUTION: Ensure that the p
roper pin is selected for AC operation. Applying power on the
wrong pin may permanently damage the SSPB, necessitating factory repair.
CAUTION:
Beware of the destructive pin depth of the mating connector. When installing an
RF mating connector with a de
structive pin depth into an RF component connector, damage
may occur to the RF component connector. A destructive pin depth is a connector having a pin
length that is too long in respect to the reference plane of the connector. The centre pins of the
con
nectors used by ADVANTECH have a precision tolerance measured in mils (1/1000 inch).
The mating connectors of the various suppliers may not be of precision types. Consequently,
the centre pins of these devices may not have the proper depth.