User manual

SOM-5786 User Manual 16
! Quick Power On Self Test [Enabled]
This field speeds up the Power-On Self Test (POST) routine by skipping retest-
ing a second, third and forth time. Setup setting default is enabled.
! First / Second / Third / Other Boot Drive
! Swap Floppy Drive [Disabled]
This item enables users to swap floppy “A” and “B” identified without change
hardware cable connection.
! Boot Up Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy “A” drive one time
! Boot Up NumLock Status [Enabled]
This item enables users to activate the Number Lock function upon system boot
! Gate A20 Option [Fast]
This item enables users to switch A20 control by port 92 or not.
! Typematic Rate Setting
This item enables users to set the two typematic controls items.
This field controls the speed at
– Typematic Rate (Chars/Sec)
This item controls the speed at system registers repeated keystrokes.
Eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
– Typematic Delay (Msec)
This item sets the time interval for displaying the first and second characters.
Four delay rate options are 250, 500, 750 and 1000.
! Security Option [Setup]
! APIC Mode [Enabled]
This item allows user to enabled of disabled “Advanced Programmable Inter-
rupt Controller”. APIC is implemented in the motherboard and must be sup-
ported by the operating system, and it extends the number of IRQ's available.
! MPS Version Control for OS [1.4]
This item sets the operating system multiprocessor support version.
! OS Select For DRAM > 64 M [Non-OS2]
Select OS2 only if system is running OS/2 operation system with greater than
64 MB of RAM on the system.
Floppy Select boot device priority by Floppy.
LS120 Select boot device priority by LS120.
Hard Disk Select boot device priority by Hard Disk.
CDROM Select boot device priority by CDROM.
ZIP Select boot device priority by ZIP.
USB-FDD Select boot device priority by USB-FDD.
USB-ZIP Select boot device priority by USB-ZIP.
USB-CDROM Select boot device priority by USB-CDROM.
USB Device Select boot device priority by USB Device.
LAN Select boot device priority by LAN.
Disabled Disable this boot function.
System System can not boot and can not access to Setup page if the cor-
rect password is not entered at the prompt.
Setup System will boot, but access to Setup if the correct password is not
entered at the prompt (Default value).