Specifications

Web GUI Monitoring & Control
4.9.4.4 Uploading a Profile
Uploading is essentially the second stage in cloning a profile.
To upload a profile:
1. Select the ‘Browse’ button. A window similar to that shown in Figure 4.39 is displayed.
Figure 4.39: Choose file Window
2. Select the file selected in the download operation.
3. Select ‘Send’ to upload the file and create a new profile.
4.9.5 Output
At the bottom of the Configuration panel is the area used to configure the output interfaces
(See figure 4.40). These interfaces are labelled ‘Output 0’, ‘Output 1’ and ‘Output 2’.
Figure 4.40: Output Interface Configuration Panel
To view the configuration information for a particular output interface:
1. Select the relevant output interface. The configuration details are displayed.
2. Change any parameters as required.
3. Select the configure button to activate the changes.
4.9.5.1 Enable/Disable
Each interface may be independently enabled or disabled using the check box. At present, the
ASI output data will continue to flow in the disabled state, but the control will be relevant to the
configuration of the stream isolation function.
4.9.5.2 Output ISI
Each output stage may be programmed to process one stream of the received DVB-S2
multiplex. The stream to be processed is determined by the Input Stream Identifier, or ISI, which
may be set to a number in the range 0 to 255.
4-42 SBD75e Series Demodulator Installation and Operation Manual