User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
77
LED Status
Indicators
Power LED:
Off: Power off
Solid green: Lit when charging in power off
mode, off when charging is complete
Blinking green: Power on, battery is
charging in power on mode
Solid yellow: Power on, battery low
Blinking yellow: Power on, battery
critically low
HDD LED:
Green when HDD is being accessed
WLAN LED:
Off: No RF signal / No LAN connection
Solid Green: WLAN activated
Blinking Green: TX/RX transmission
Other Components
CCD Camera 2M
Fingerprint scanner
TMP 1.2
I/O Port
Two USB 2.0 host connector
One RS-232
One VGA output
One SD card reader (external memory card)
One PCMCIA slot
One U SIM Card Slot
One stereo headphone jack
One microphone jack
One DC-In jack
One docking connector
Physical
264 x 213 x 18mm
Approx. 1.2Kg
Environment
Operating Temperature: 0ºC to 40ºC
Storage Temperature -20ºC to 60ºC
Operating Humidity 5% ~ 95%
Rugged Rating
IP54
3ft drop
Feature Description