User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
42
2. Place the barcode in front of the barcode scanner, observe
proper angle to ensure successful reading (see below).
3. Press to scan the barcode.
Ensure mode is disabled to use the scanner
function. Otherwise, press .
S2
S2
S2
± 25º Normal ± 75º Normal± 60º Normal
Barcode Scanner Skew, Pitch, and Roll
Barcode Scanner Decode Zone
S2
Note
MODE