User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
36
Next to continue. (Skip to step 8 if you decide to configure
each computer manually.)
6. Insert your USB flash drive into
a free USB slot and select the
drive name from the drop-
down list.Tap Next to continue.
7. All your current network
settings are copied to your USB
flash disk. Tap Next to
continue.
8. Setup is complete. Tap Print
Network Settings to print a list
of settings if you are
configuring each computer
manually. Tap Finish to
complete the wizard.
9. If you chose to transfer settings
to other computers via your USB
flash disk, select Wireless Network
Setup Wizard from the prompt that
appears when you insert the disk
into other computers. The network
settings are transferred
automatically.