User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
30
Using the Mode Button
Press to enable or disable mode.
• When mode is enabled, press and to adjust the
brightness setting.
• When mode is disabled, functions as the F4 key while
functions as the F5 key. If a barcode scanner is installed,
functions as the barcode switch key.
Adjusting Screen Brightness
1. Ensure mode is enabled.
2. Press
to decrease brightness, or to increase brightness.
Adjusting the Volume
1. Tap the Volume icon on the system tray.
2. Move the slide to adjust volume.
MODE
S1
S2
S1
S2
S2
S1
S2