User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
27
2. Tap the Calibrate tab and
you will see two options:
• Standard Calibration: select
this option to start 5 points
Standard Calibration.
• Advanced Calibration: select
this option to use 4, 9, 16, or
25 points to calibrate the
screen. Check Plot
calibration data to enable touch panel linearity comparison
graph. The blue lines show linearity before calibration and
black lines show linearity after calibration.
3. Touch the points as displayed
onscreen using the pen.