User's Manual
Table Of Contents
- Table of Contents
- Preface
- Safety Instructions
- Rugged and Ready to Go
- Getting Started
- Installing the Rubber Bumpers
- Removing the Rubber Bumpers
- Using the Power Switch
- Inserting a Memory Card
- Removing a Memory Card
- Installing a 3G SIM Card
- Removing 3G SIM Card (optional)
- Installing a WWAN Module (optional)
- Installing an MSR (optional)
- Installing a 1D Barcode Scanner (optional)
- Installing an RFID (optional)
- Upgrading Components
- Making Connections
- Turning On
- Wireless Connections
- Using the Modules
- Using the Fingerprint Software
- Advanced Settings
- Troubleshooting
- Appendix
S10A User Manual
11
Installing a 3G SIM Card
You can install a 3G SIM Card into
the SIM card slot located inside
the middle compartment.
1. Make sure the system is turned off.
Unscrew the middle compartment
cover.
2. Push the SIM card into the slot,
with the metallic part facing up
and the clipped corner facing
inward, until it clicks into place.
3. Screw the middle compartment
cover.
Removing 3G SIM Card (optional)
Slightly push the SIM Card inwards to pop
it out.
Ensure that the system is turned off before
inserting or removing the SIM card.
Note