User`s manual

IPPC-9120G/9150G Users Manual 46
Chapter 5 PCI Bus Ethernet Interface
5.1 Introduction
The IPPC-9120G/9150G is equipped with a high performance 32-bit
Ethernet chipset, which is fully compliant with IEEE 802.3 100 Mbps
CSMA/CD standards. It is supported by major network operating sys-
tems. It is also both 100Base-T and 10Base-T compatible.
The Ethernet port provides a standard RJ-45 jack. The network boot fea-
ture can be utilized by incorporating the boot ROM image files for the
appropriate network operating system. The boot ROM BIOS files are
combined with system BIOS, which can be enabled/disabled in the BIOS
setup.
5.2 Installation of Ethernet Driver
Before installing the Ethernet driver, note the procedures below. You
must know which operating system you are using in your IPPC-9120G/
9150G, and then refer to the corresponding installation flow chart. Then
just follow the steps described in the flow chart. You will quickly and
successfully complete the installation, even if you are not familiar with
instructions for Windows.
Important: The following windows illustrations are examples only. You
must follow the flow chart instructions and pay attention to the instruc-
tions which then appear on your screen.
Note 1: The CD-ROM drive is designated as "D" through-
out this chapter.
Note 2: <Enter> means pressing the "Enter" key on the
keyboard.