User`s manual

2.6 Installing System Memory
The serverboard has four 168-pin DIMM sockets for
3.3V Registered PC-133 compliant SDRAM with ECC. The
approved SDRAM modules are showed in Appendix A. You
can install any configuration specified in the server
specification table. Always observe static electricity
precautions when installing memory. To install DIMM
modules do as follows:
Press the socket retaining latches back out of the way.
Orient the module so that the edge connector sections
correctly match the socket sections. Holding the module to
the socket, place it in the socket so that the edge connectors
insert slightly in the socket. Make sure they match.
RS-200-RT User’s Manual
43