User`s manual

RS-100-RT User’s Manual

Orient the CPU to the socket correctly so that the pins match

the receptacles. Insert the CPU in the socket so that the pins

fully insert.

Lower the retaining lever so that the CPU locks in place and

latch the arm to the side of the socket.

Repeat this operation for the second CPU. If you will

only install one CPU, it is necessary to install an optional

CPU terminator in another slave CPU socket. The procedure

of installing CPU terminator is the same as CPU.

Warning: Without a fan or heat sink, a CPU will overheat

and cause damage to both the CPU and the main board. It is

not necessary to install CPU cooler fan for CPU terminator.