User`s manual

Chapter 4 PCI SVGA Setup 45
4.1.4 VGA display software configuration (PCN-6351L)
The PCN-6351L's on-board VGA interface supports traditional analog
CRT monitors. The VGA controller is built into the system's chip
(SIS5598) It can supports 1 to 4 MB of video memory share with the
system memory. The interface can drive CRT displays with resolu-
tions up to 1024 x 768 in 256 colors at 1 MB share memory, as well
as up to 1280 x 1024 in 64 K colors at 3 MB share memory. The VGA
interface is configured completely via the software utility, so you do
not have to set any jumpers.
4.2 Installation of SVGA Driver
(PCN-6351 only)
Complete the following steps to install the SVGA driver. Follow the
procedures in the flow chart that apply to the operating system that
you are using within your PCN-6351.
Important: The following windows illustrations are examples
only. You must follow the flow chart instructions and
pay attention to the instructions which then appear
on your screen.
Note: <Enter> means pressing the “Enter” key on the
keyboard.