User manual

25 PCM-9590 User Manual
Chapter 3 BIOS Operation
 First / Second / Third / Other Boot Drive
 Swap Floppy Drive [Disabled]
This item enables users to swap floppy “A” and “B” identified without change
hardware cable connection.
 Boot Up Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy “A” drive one time.
 Boot Up NumLock Status [Disabled]
This item enables users to activate the Number Lock function upon system boot.
 Typematic Rate Setting
This item enables users to set the two typematic controls items.
This field controls the speed at
– Typematic Rate (Chars/Sec)
This item controls the speed at system registers repeated keystrokes.
Eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
– Typematic Delay (Msec)
This item sets the time interval for displaying the first and second characters.
Four delay rate options are 250, 500, 750 and 1000.
 Security Option [Setup]
– System
System can not boot and can not access to Setup page if the correct pass-
word is not entered at the prompt.
– Setup
System will boot, but access to Setup if the correct password is not entered
at the prompt. (Default value)
 MPS Version Control for OS [1.4]
This item sets the operating system multiprocessor support version.
 OS Select For DRAM > 64M [Non-OS2]
Select OS2 only if system is running OS/2 operation system with greater than 64
MB of RAM on the system.
Floppy Select boot device priority by Floppy.
LS120 Select boot device priority by LS120.
Hard Disk Select boot device priority by Hard Disk.
CDROM Select boot device priority by CDROM.
ZIP Select boot device priority by ZIP.
USB-FDD Select boot device priority by USB-FDD.
USB-ZIP Select boot device priority by USB-ZIP.
USB-CDROM Select boot device priority by USB-CDROM.
USB-HDD Select boot device priority by USB-HDD.
LAN Select boot device priority by LAN.
Disabled Disable this boot function.