User manual

PCM-9342 User Manual 24
 IDE HDD Block Mode [Enabled]
This item allows enabled or disabled that IDE block data transfer mode. It will
speed up HDD data transfer of efficiency. Bios default value suggest to
“Enabled”.
 Onboard FDC Controller [Enabled]
This item specifices onboard floppy disk drive controller.
 Onboard Serial Port 1 [3E8]
This option is used to assign the I/O address and IRQ for the onboard serial
port.
 Serial Port 1 Use IRQ [IRQ3]
This option is used to assign the Serial Port 3 Use IRQ.
 Onboard Serial Port 2 [2E8]
This option is used to assign the I/O address and IRQ for the onboard serial
port.
 Serial Port 2 Use IRQ [IRQ4]
This option is used to assign the Serial Port 4 Use IRQ.
 Onboard Parallel Por [378/IRQ7]
This item allows you to determine onboard parallel port controller I/O address
and IRQ.
 Parallel Port Mode [Standard]
Select an operating mode for the onboard parallel port.
 ECP Mode Use DMA [3]
When the onboard parallel is set to ECP mode, the parallel port can use DMA3
or DMA1.
3.2.6 PC Health Status
Note! This entry displays the current system temperature, and Voltage.