User manual

11 PCM-9342 User Manual
Chapter 2 H/W Installation
2.2 Connectors
2.2.1 Connector list
2.2.2 Connector Settings
2.2.2.1 VGA/LCD/LVDS interface connections
The board’s PCI VGA interface can drive conventional CRT displays and is capable
of driving a wide range of flat panel displays, including passive LCD and active LCD
displays. The board has connectors to support these displays: one for standard CRT
VGA monitors, one for flat panel displays, and one for LVDS type LCD panels.
2.2.2.2 CRT display connector (CN5)
The CRT display connector is a 15-pin D-SUB connector used for conventional CRT
displays.
2.2.2.3 SATA Connector (CN6, CN7)
PCM-9342 supports Serial ATA via two connectors (CN6, CN7). Data transfer rates
up to 100 MB/s are possible, enabling very fast data and file transfer, and indepen-
dent DMA operation on two ports.
2.2.2.4 USB connectors (CN9)
The board provides up to two USB (Universal Serial Bus) ports. This gives complete
plug and play capability. The USB interfaces comply with USB specification Rev.
2.0which supports 480 Mbps transfer rate, and are fuse protected 5 x 2 pin 180D (M)
connectors for internal 2 x USB connectors at CN9.You will need an adapter cable if
you use a standard USB connector. The adapter cable has a 5 x2-pin connector with
foolproof protection for incorrect plug-in on one end and a USB connector on the
other.
CN5 VGA
CN6 SATA
CN7 SATA
CN9 Internal USB
CN11 COM2
CN12 LPT
CN14 COM3
CN15 COM4
CN16 24 bits TTL Panel
CN17 Inverter Power Output
CN18 18 bits LVDS Panel
CN19 LAN
CN20 ISA -5V & -12V Input
CN21 PC104
CN25 AT Power Input
CN32 GPIO
CN33 Battery
CN34 PS2
CN35 CF
CN36 COM1