User manual

25 Chapter 3
There are four selections for Power Management, three of which have
fixed mode settings
3.7.3 Video Off In Suspend
When system is in suspend, video will turn off.
3.7.4 Modem Use IRQ
This determines the IRQ which the MODEM can use. The choices: 3, 4,
5, 7, 9, 10, 11, NA.
3.7.5 HDD Power Down
You can choose to turn the HDD off after one of the time intervals listed,
or when the system is in “suspend” mode. If the HDD is in a power sav-
ing mode, any access to it will wake it up.
3.7.6 PowerOn By Modem
When Enabled, an input signal on the serial Ring Indicator (RI) line (in
other words, an incoming call on the modem) awakens the system from a
soft off state. The choices: Enabled, Disabled.
3.7.7 PowerOn By Alarm
When Enabled, your can set the date and time at which the RTC (real-
time clock) alarm awakens the system from Suspend mode. The choices:
Enabled, Disabled.
3.7.8 Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) is active. The choices are: Enabled,
Disabled.
3.7.9 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if FDD, COM
port, or LPT port is active. The choice: Enabled, Disabled.
3.7.10 PCI PIRQ [A-D]#
Min. Power Saving Minimum power management., Suspend Mode = 1 hr.,
and HDD Power Down = 15 min.
Max. Power Saving Maximum power management., Suspend Mode = 1 min.,
and HDD Power Down = 1 min.
User Defined
(Default)
Allows you to set each mode individually. When not dis-
abled, each of the ranges are from 1 min. to 1 hr. except
for HDD Power Down which ranges from 1 min. to 15 min.
and disable.