Specifications

Chapter 3 Software Installation 19
FF
FF
F
olloollo
olloollo
ollo
wing completion of installawing completion of installa
wing completion of installawing completion of installa
wing completion of installa
tion,tion,
tion,tion,
tion,
please r please r
please r please r
please r
estarestar
estarestar
estar
t yt y
t yt y
t y
our system asour system as
our system asour system as
our system as
prompted.prompted.
prompted.prompted.
prompted.
Once the boarOnce the boar
Once the boarOnce the boar
Once the boar
d and drd and dr
d and drd and dr
d and dr
ii
ii
i
vv
vv
v
er haer ha
er haer ha
er ha
vv
vv
v
e been installed and the systeme been installed and the system
e been installed and the systeme been installed and the system
e been installed and the system
restarts successfully, users can execute any ready-made applica-restarts successfully, users can execute any ready-made applica-
restarts successfully, users can execute any ready-made applica-restarts successfully, users can execute any ready-made applica-
restarts successfully, users can execute any ready-made applica-
tions, such as HyperTerminal to transmit/receive data, or Remotetions, such as HyperTerminal to transmit/receive data, or Remote
tions, such as HyperTerminal to transmit/receive data, or Remotetions, such as HyperTerminal to transmit/receive data, or Remote
tions, such as HyperTerminal to transmit/receive data, or Remote
Access Service to provide dial-up networking capability.Access Service to provide dial-up networking capability.
Access Service to provide dial-up networking capability.Access Service to provide dial-up networking capability.
Access Service to provide dial-up networking capability.
Configuration:
Enter the configuration program to install the device driver, or click
the Taskbar [
StartStart
StartStart
Start ] button, then select the [
ProgramsPrograms
ProgramsPrograms
Programs] menu, then the
[
Advantech Icom UtilityAdvantech Icom Utility
Advantech Icom UtilityAdvantech Icom Utility
Advantech Icom Utility ] menu and then [
IcomIcom
IcomIcom
Icom].
W hen the conf igur ation panel pops up,
click the [
Add BoardAdd Board
Add BoardAdd Board
Add Board] button to add a board.
Clic k the [
DeleteDelete
DeleteDelete
Delete ] button to r e m o v e a boar d .
BoarBoar
BoarBoar
Boar
d d
d d
d
TT
TT
T
ype:ype:
ype:ype:
ype: PCL-846
Base COM: Base COM:
Base COM: Base COM:
Base COM: Specifies the COM number of the first port. Subsequent
ports are mapped to subsequent COM numbers. For instance, if the
first port is mapped to COM10, then the second port is mapped to
COM11 sequentially.
Base Address (200H~3F8H):Base Address (200H~3F8H):
Base Address (200H~3F8H):Base Address (200H~3F8H):
Base Address (200H~3F8H): Specifies the base address of the first
port. Subsequent base addresses are mapped to subsequent COM
numbers. For instance, if the first port is mapped to 300H, then the
second port is mapped to 308H sequentially.
PCL-846 series cards can be installed together in a single system as
long as the system memor y r esour ces are sufficient and a v ailable in a
system. Different boards should be assigned different IRQs.
Click the [
Share IRQ EnableShare IRQ Enable
Share IRQ EnableShare IRQ Enable
Share IRQ Enable ] button to set the share IRQ function.