User manual

PCL COMMUNICATION User Manual viii
Figure 2.20:Standard or Enhanced Mode selection for
PCL-849A/B/+ ................................................. 23
Figure 2.21:Port Base Address Setting ........................ 24
Figure 2.22:Setting to 2F8 ........................................... 25
Figure 2.23:Shared or Independent IRQ selection for
PCL-746+ ........................................................ 26
Figure 2.24:Shared or Independent IRQ selection for S2
of PCL-746+ and S1 of PCL-849A/B/+ .......... 26
Figure 2.25:IRQ Selection ........................................... 27
2.3.6 Interrupt Status Register Setup (SW2 or S5) ............... 27
2.3.7 Interrupt Status Register .............................................. 28
Figure 2.26:Vector Address Setting ............................. 28
Figure 2.27:Vector Address Setting ............................. 28
2.3.8 Speed Mode selection .................................................. 29
Chapter 3 Software Installation..................................... 32
3.1 Operating Environment Selection ................................... 32
Figure 3.1:OS Jumper Selection .................................. 32
3.2 Driver Setup .................................................................... 32
3.2.1 Steps for Windows 98/2000/XP Driver Setup ............. 32
3.3 Configuring ISA ICOM Serial Devices .......................... 39
3.4 Driver Uninstallation....................................................... 42
Chapter 4 ICOM Tools ................................................... 46
4.1 Introduction .................................................................... 46
4.2 Installation....................................................................... 46
4.3 User Interface of ICOM Tools ........................................ 47
4.3.1 Menu Bar ..................................................................... 47
4.3.2 Tool Bar ....................................................................... 48
4.3.3 Com Port Tab ............................................................... 49
4.3.4 Port Status .................................................................... 50
4.3.5 Message Logo .............................................................. 50
4.3.6 Tx Slide Bar ................................................................. 51
4.3.7 Performance Listing Area ............................................ 51
4.3.8 Status Bar ..................................................................... 51
4.4 Using the ICOM Tools Utility ........................................ 52
4.4.1 Port Selection ............................................................... 52
Figure 4.1:ICOM Tools program window ................... 52
Figure 4.2:Select Port dialog box ................................ 53
Figure 4.3:Ports You Select Will Appear in the Selected
Port Checkbox Group ...................................... 53
Figure 4.4:ICOM Tools User Interface ........................ 54
4.4.2 Configuring a Port ....................................................... 54
Figure 4.5:Test Information on the Performance Listing
Area .................................................................. 55
4.4.3 Close Port ..................................................................... 56
4.4.4 Exit the ICOM Tools utility ......................................... 56