User manual

Table 3-2: Summary of jumper settings

Names of Jumpers Function description

Keep last status after hot reset

JP2

Default configuration

Setting the time to reset the digital outputs

Some users will want the capability of clearing each digital output

when the system (or PC) issues a reset signal on the PCI bus. Some

users will want to clear their digital outputs only as part of system

power-on. The PCI-1730 satisfies both these needs by providing

jumper JP2. Depending on the application, this capability may allow

digital outputs to be "OFF" without requiring a complete shutdown of

processes controlled by the card.

Complete loss of power to the chip clears the chip memory. Thus, no

matter how JP2 is set, if the power to the PCI-1730 is disconnected, the

digital output channel’s initial power-on state will be "OFF".

Board ID setting (SW1)

ID3 ID2 ID1 ID0 Board ID

1 1 1 1 0

1 1 1 0 1

1 1 0 1 2

1 1 0 0 3

1 0 1 1 4

1 0 1 0 5

1 0 0 1 6

1 0 0 0 7

0 1 1 1 8

0 1 1 0 9

0 1 0 1 10

0 1 0 0 11

0 0 1 1 12

0 0 1 0 13

0 0 0 1 14

0 0 0 0 15

Note: On: 1, Off: 0