User manual

43 Chapter 5
Step 9a:Once the Status indicates Failed, please check if both the wiring
and the input voltage are correct. When finished checking, click the Start
button again to restart the procedure, or click the Cancel button to stop
the calibration.
Figure 5.10: Gain Calibration Failed
Step 10:When the current channel is calibrated, click the Finish button to
end the procedure. You can proceed to Step 3 to select another channel
for calibration, and repeat from Step 4 to Step 9, until the rest of the chan-
nels are all calibrated one after one.
Figure 5.11: Calibration Procedure Completed