User manual

41 Chapter 5
Step 6a:Once the Status indicates Failed, please check if both the wiring
and the input voltage are correct. When finished checking, click the Start
button again to restart the procedure, or click the Cancel button to stop
the calibration.
Figure 5.6: Offset Calibration Failed
Step 7:If the offset calibration is completed, it will proceed to the Gain
Calibration. The steps of gain calibration are quite similar to those of the
offset calibration. Follow the instructions of the Calibration Wizard to
input a correct DC voltage and click the Next button to proceed.,
Figure 5.7: The Start-up Window of Offset Calibration