User manual

PCI-7020 User Manual 36
! FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if the FDD, inter-
face, COM port, or LPT port is active. The choices are “Enabled” and “Dis-
abled”.
! PCI PIRQ [A-D]#
When Enabled, the system resumes from suspend mode if an interrupt occurs.
The choices are “Enabled” and “Disabled”.
! PWRON After PWR-Fail
Use this to set up the system after power failure. The “Off” setting keeps the sys-
tem powered off after power failure, the “On” setting boots up the system after
failure, and the “Former-Sts” returns the system to the status before power fail-
ure.
3.8 PnP/PCI Configurations
Figure 3.11 PnP/PCI configurations screen
! Reset Configuration Data
The default is Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) if you have installed a new add-on card, and system configuration
is in such a state that the OS cannot boot.
! Resources Controlled By
The commands here are “Auto (ESCD)” or “Manual”. Choosing “Manual”
requires you to choose resources from the following sub-menu. “Auto (ESCD)”
automatically configures all of the boot and Plug and Play devices, but you must
be using Windows 95 or above.
! PCI / VGA Palette Snoop
This is set to “Disabled” by default.
! Maximum Payload Size
This allows you to set the maximum TLP payload size for PCI Express devices.
The options are [128 bytes].