Specifications

28 PCI-6771 User's Manual
2.33 AT Power Connector (CN23)
If you prefer not to acquire power through PCI-6771’s backplane
via the gold H-connectors, CN23 also provides power input
connectors for +5 V and +12 V. (see Appendix C)
2.34 CompactFlash Disk (CN24)
The PCI-6771 is equipped with a CompactFlash™ disk socket on
the solder side that supports the IDE interface for CompactFlash
cards. The on-board CompactFlash socket is designed to prevent
incorrect installation. Be sure that the system power is off when
installing and removing CompactFlash™ cards.
The CompactFlash card is defaulted as the Secondary channel
slave drive on your PC system.
2.35 Installing System Memory (SODIMMs)
You can install anywhere from 8 to 256 MB of SDRAM into your
PCI-6771 series card. The card provides two 144-pin SODIMM
sockets. Each socket accepts 8, 16, 32, 64 or 128 MB 3.3 V power
level SODIMMs. If only one SODIMM module is installed, it may
be installed in either SODIMM socket on the solder side of the
PCI-6771 series card.
Note: PCI-6771 card only supports SDRAM SODIMM
modules. EDO SODIMM is not supported.
2.35.1 Installing SODIMMs
Note 1:The modules can only fit into a socket one way. Their
gold pins must point down into the SODIMM socket.
Please refer to the diagram below for dimensions.