User manual

PCI-1762 User Manual 14
2.6 Device Setup & Configuration
The Advantech Device Manager program is a utility that allows you to set up, config-
ure and test your device, and later stores your settings on the system registry. These
settings will be used when you call the APIs of Advantech Device Drivers.
Setting Up the Device
1. To install the I/O device for your card, you must first run the Device Manager
program (by accessing Start/Programs/Advantech Automation/Device Manager/
Advantech Device Manager ).
2. You can then view the device(s) already installed on your system (if any) on the
Installed Devices list box. If the software and hardware installation are com-
pleted, you will see PCI-1762 card in the Installed Devices list.
Figure 2.6 Device Manager Dialog Box
Configuring the Device
3. Click the Setup button to configure your device. On the Device Setting dialog
box (Fig. 2-7), you can configure the ID0/ID8 Interrupt trigger mode either as
Rising Edge or Falling Edge, and Enable of Disable the ID0/ID8.