User manual

13 PCI-1762 User Manual
Chapter 2 Installation
7. Connect appropriate accessories (62-pin cable, wiring terminals, etc. if neces-
sary) to the PCI card.
8. Replace the cover of your computer chassis. Re-connect the cables you
removed in step 2.
9. Plug in the power cord and turn on the computer.
After the PCI-1762 card is installed, you can verify whether it is properly installed on
your system in the Device Manager:
1. Access the Device Manager through Control Panel/System/Device Manager.
2. The device name of the PCI-1762 should be listed on the Device Manager tab
on the System Property Page.
Figure 2.5 Device Name on the Device Manager
After your card is properly installed on your system, you can now configure your
device using the Device Installation Program that has itself already been installed on
your system during driver setup. A complete device installation procedure should
include device setup, configuration and testing. The following sections will guide you
through the Setup, Configuration and Testing of your device.
Note! If your card is properly installed, you should see the device name of
your card listed on the Device Manager tab. If you do see your device
name listed on it but marked with an exclamation sign "!", it means your
card has not been correctly installed. In this case, remove the card from
the Device Manager by selecting its device name and press the Remove
button. Then go through the driver installation process again.