Specifications

Chapter 2
– 18 –PCI-1762 User’s Manual
Advantech Co., Ltd.
www.advantech.com
Configuring the Device
Step 4: On the Device Setting dialog box (Fig. 2-9), you can configure
the ID0/ID8 Interrupt trigger mode either as Rising Edge or
Falling Edge, and Enable of Disable the ID0/ID8.
Figure 2-10: The Device Name appearing on the list of devices box
Note:
✎ As we have noted, the device name “000: <PCI-1762 I/O=EC00H> ”
begins with a device number “000”, which is specifically assigned to
each card. The device number is passed to the driver to specify which
device you wish to control.
If you want to test the card device further, go right to the next section
on the Device Testing.
Figure 2-9: The Device Setting dialog box
Step 5: After you have finished configuring the device, click OK and
the device name will appear in the Installed Devices box as
seen below: