User manual

11 Chapter 2
Step 6: Insert the PCI-1752U/PCI-1752USO card into a PCI slot. Hold
the card only by its edges and carefully align it with the slot. Insert the
card firmly into place. Use of excessive force must be avoided, otherwise
the card might be damaged.
Step 7: Fasten the bracket of the PCI card on the back panel rail of the
computer with screws.
Step 8: Connect appropriate accessories (100-pin cable, wiring termi-
nals, etc. if necessary) to the PCI card.
Step 9: Replace the cover of your computer chassis. Re-connect the
cables you removed in step 2.
Step10: Plug in the power cord and turn on the computer.
After the PCI-1752U/PCI-1752USO card is installed, you can verify
whether it is properly installed on your system in the Device Manager:
1. Access the Device Manager through Control Panel/System/Device
Manager.
2. The device name of the PCI-1752U/PCI-1752USO should be listed
on the Device Manager tab on the System Property Page.
Note: In case you installed the card without installing
the DLL driver first, Windows XP/2000 will rec-
ognize your card as an “unknown device” after
reboot, and will prompt you to provide neces-
sary driver. You should ignore the prompting
messages (just click the Cancel button) and
set up the driver according to the steps
described in Section 2.2 Driver Installatio