Specifications

Comedi
104 / 148
This card has 16 analog inputs multiplexed onto a 12 bit ADC. There
is a minimally useful onboard clock. The base frequency for the
clock is selected by jumpers, and the clock divider can be selected
via programmed I/O. Unfortunately, the clock divider can only be
a power of 10, from 1 to 10^7, of which only 3 or 4 are useful. In
addition, the clock does not seem to be very accurate.
5.5.46 dt2815 -- Data Translation DT2815
Author: ds
Status: mostly complete, untested
Manufacturer Device Name
Data Translation DT2815 dt2815
I’m not sure anyone has ever tested this board. If you have information
contrary, please update.
Configuration options:
[0] - I/O port base base address
[1] - IRQ (unused)
[2] - Voltage unipolar/bipolar configuration
0 == unipolar 5V (0V -- +5V)
1 == bipolar 5V (-5V -- +5V)
[3] - Current offset configuration
0 == disabled (0mA -- +32mAV)
1 == enabled (+4mA -- +20mAV)
[4] - Firmware program configuration
0 == program 1 (see manual table 5-4)
1 == program 2 (see manual table 5-4)
2 == program 3 (see manual table 5-4)
3 == program 4 (see manual table 5-4)
[5] - Analog output 0 range configuration
0 == voltage
1 == current
[6] - Analog output 1 range configuration (same options)
[7] - Analog output 2 range configuration (same options)
[8] - Analog output 3 range configuration (same options)
[9] - Analog output 4 range configuration (same options)
[10] - Analog output 5 range configuration (same options)
[11] - Analog output 6 range configuration (same options)
[12] - Analog output 7 range configuration (same options)
5.5.47 dt2817 -- Data Translation DT2817
Author: ds