User manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Configuration
- 2.1 Initial Inspection
- 2.2 Jumper and Switch Locations
- Figure 2.1: PCI-1601A/B Silk Screen
- Figure 2.2: PCI-1601AU/BU Silk Screen
- Figure 2.3: PCI-1602A/B Silk Screen
- Figure 2.4: PCI-1602AU/BU Silk Screen
- Figure 2.5: PCI-1602UP Silk Screen
- Figure 2.6: PCI-1603 Silk Screen
- Figure 2.7: PCI-1604UP Silk Screen
- Figure 2.8: PCI-1610A/B Silk Screen
- Figure 2.9: PCI-1610CU Silk Screen
- Figure 2.10: PCI-1610AUP/UP Silk Screen
- Figure 2.11: PCI-1610AJP Silk Screen
- Figure 2.12: PCI-1611U Silk Screen
- Figure 2.13: PCI-1612A/B Silk Screen
- Figure 2.14: PCI-1612AU/U Silk Screen
- Figure 2.15: PCI-1612CU Silk Screen
- Figure 2.16: PCI-1620A/B Silk Screen
- Figure 2.17: PCI-1620AU/U Silk Screen
- Figure 2.18: PCI-1622CU Silk Screen
- 2.3 Jumper Settings
- 2.3.1 How to Set Jumpers
- 2.3.2 Default Settings
- 2.3.3 Mode Selection by Jumper/DIP Settings
- Figure 2.21: PCI-1612 Series RS-232/422/485 Selection
- Figure 2.22: RS-422/485 Selection by Jumper Setting
- Figure 2.23: PCI-1603 RS-232 Mode Jumper Setting
- Figure 2.24: PCI-1603 Current-loop Mode Jumper Setting
- Figure 2.25: Active Mode Jumper Setting
- Figure 2.26: Passive Mode Jumper Setting
- Figure 2.27: Resistor Selection
- 2.4 Card Installation
- Chapter 3 Driver Setup & Installation
- Chapter 4 ICOM Tools
- Chapter 5 Pin Assignments and Wiring
PCI-COMMUNICATION User Manual 74
Chapter 5 Pin Assignments and Wiring
5.1 Pin assignments
5.1.1 PCI-1601A/AU/B/BU, PCI-1602A/AU/B/BU
The following table and figure shows the pin assignments for the PCI-
1601A/B/AU/BU, and PCI-1602A/B/AU/BU cards’ male DB9 connec-
tors on the bracket in RS-422 and RS-485 modes.
Figure 5.1: PCI-1601/1602 Pin Assignment
Table 5.1: PCI-1601/1602 Male DB9 on bracket
Pin RS-422 RS-485
1 Tx- Data-
2 Tx+ Data+
3 Rx+ -
4 Rx- -
5GND GND
6RTS- -
7RTS+ -
8CTS+ -
9CTS- -