User manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Hardware Configuration
- 2.1 Initial Inspection
- 2.2 Jumper and Switch Locations
- Figure 2.1: PCI-1601A/B Silk Screen
- Figure 2.2: PCI-1601AU/BU Silk Screen
- Figure 2.3: PCI-1602A/B Silk Screen
- Figure 2.4: PCI-1602AU/BU Silk Screen
- Figure 2.5: PCI-1602UP Silk Screen
- Figure 2.6: PCI-1603 Silk Screen
- Figure 2.7: PCI-1604UP Silk Screen
- Figure 2.8: PCI-1610A/B Silk Screen
- Figure 2.9: PCI-1610CU Silk Screen
- Figure 2.10: PCI-1610AUP/UP Silk Screen
- Figure 2.11: PCI-1610AJP Silk Screen
- Figure 2.12: PCI-1611U Silk Screen
- Figure 2.13: PCI-1612A/B Silk Screen
- Figure 2.14: PCI-1612AU/U Silk Screen
- Figure 2.15: PCI-1612CU Silk Screen
- Figure 2.16: PCI-1620A/B Silk Screen
- Figure 2.17: PCI-1620AU/U Silk Screen
- Figure 2.18: PCI-1622CU Silk Screen
- 2.3 Jumper Settings
- 2.3.1 How to Set Jumpers
- 2.3.2 Default Settings
- 2.3.3 Mode Selection by Jumper/DIP Settings
- Figure 2.21: PCI-1612 Series RS-232/422/485 Selection
- Figure 2.22: RS-422/485 Selection by Jumper Setting
- Figure 2.23: PCI-1603 RS-232 Mode Jumper Setting
- Figure 2.24: PCI-1603 Current-loop Mode Jumper Setting
- Figure 2.25: Active Mode Jumper Setting
- Figure 2.26: Passive Mode Jumper Setting
- Figure 2.27: Resistor Selection
- 2.4 Card Installation
- Chapter 3 Driver Setup & Installation
- Chapter 4 ICOM Tools
- Chapter 5 Pin Assignments and Wiring
93 Chapter 5
For DTE to DCE connections, use a straight through cable (i.e., you don't
have to reverse lines 2 and 3, lines 4 and 5, and lines 6 and 20 since, in
general, the DCE RS-232 interfaces are reversed themselves).
Therefore, if you are not using CTS, RTS, DSR ,DTR and DCD signals,
please short pins 4 and 5 together, and please short pins 6, 8,and 20
together.
Table 5.29: Modem Connections
DB-25 Male Modem (DCE)
Pin Signal Pin Signal
2 TxD 2 RxD
3 RxD 3 TxD
4RTS 4 CTS
5CTS 5 RTS
6DSR 6 DTR
7 GND 7 GND
20 DTR 20 DSR
8 DCD 8 DCD
Table 5.30: Terminal without Handshake
DB-25 Male Terminal, PC (DTE)
Pin Signal Pin Signal
2TxD 3 RxD
3 RxD 2 TxD
4
5
RTS —
CTS —
7 GND 7 GND
6
20
8
DSR —
DTR —
DCD —