User manual

51 PCI/ PCI Express-Communication User Manual
Chapter 4 ICOM Tools
Figure 4.6 Test Information on the Performance Listing Area
The Performance Listing Area
Stop the Test
If you want to stop the test on a specific port, just click Port Stop button or access
Port/Stop menu command (or if you want to stop test on all ports, just click All Ports
Stop button or access All Ports/Stop menu command).
You can restart the test by clicking the Run button or accessing the Port/Run
menu command (or if you want to run all ports at once, just click the All Ports Run
button or access All Ports/Run menu command).
4.4.3 Close Port
If you want to close a port, just select the Com Port tab and click Port Close button
or access Port/Close menu command to close the port.
4.4.4 Exit the ICOM Tools utility
To exit the ICOM Tools utility, simply access Port/Exit menu command or click the
Close button on the upper right corner of the program window.
4.5 Messages on Status Bar and Message Logo
Area
Messages appearing on the Status Bar and Message Logo area are helpful in under-
standing specific information of your system settings and performance.
4.5.1 Status Bar Messages
BUSY: the port is currently used by another application.
FAIL: the configuration parameters are not accepted by the port
Port The com port number
Rx length Received packet length in bytes
Bytes/Sec Transmission rate in Bytes/Sec
Last Abnormal Status Last abnormal status