Specifications

Chapter 4 ICOM Tools
Close Port
If you want to close a port, just select the Com Port tab and click Port
Close button or access Port/Close menu command to close the
port.
Exit the ICOM Tools utility
To exit the ICOM Tools utility, simple access Port/Exit menu com-
mand or click the Close button on the upper right corner of the
program window.
Messages on the Status Bar and
Message Logo area
Messages appearing on the Status Bar and Message Logo area are
helpful in understanding specific information of your system settings
and performance.
Status Bar messages
BUSY: the port is currently used by other application.
FAIL: the configuration parameters are not accepted by the port
N/A PORT: the port is not available in the system
READY: the port is ready to run or configure.
RUNNING: the test is running on the port
STOPPED: the test running on the port has been stopped by user
Message Logo messages
Port Opened: Users has opened the port
Port Setup Fail: Users set up port configuration with parameters
that are either incorrect or unsupported.
Port Running: The port is running test
Port Stopped: The test is stopped on the port