Specifications

Chapter 4 ICOM Tools
You can choose to configure a specific port (or to configure all ports)
before running your test. Just click a Com Port Tab to select the port
you want to configure, and then click the Port Setup button or
just access the Port/Setup menu command (or if you want to config-
ure all ports at once, just click the All Ports Setup button or
access the All Ports/Setup menu command) to bring up the Configure
Port dialog box such as below.
On the Configure Port dialog box, you can configure the Baud Rate,
Data bits, Parity, Stop Bits and the flow control mode for that specific
port (or for all ports). After you have configured all the settings you
want to change, just click Ok to make this configuration active.
NOTE: When using All Ports Setup button or All Ports/Setup
menu command to configure settings for all ports, you must take care
to stop any ports that are running test in order to configure them. If
you do not stop the test running on a specific port, it won’t be
configured at all. That is, you get to configure only the ports that
have been stopped.
Run the test
After you have completed the configuration of the port(s), you can
now start the test on the port you have selected by clicking the Run
button or accessing the Port/Run menu command (or you want to