User manual

PCE-7210 User Manual 20
Chapter 2 Connecting Peripherals
2.1 Introduction
You can access most of the connectors from the top of the board while it
is installed in the chassis. If you have a number of cards installed or have
a packed chassis, you may need to partially remove the card to make all
the connections.
2.2 1st & 2nd IDE Connectors (IDE1, IDE2)
Figure 2.1: PCE-7210 IDE1 and IDE2 location
You can attach up to four IDE (Integrated Drive Electronics) drives to the
PCE-7210's built-in controller. The primary (IDE1) and secondary
(IDE2) connectors can each accommodate two drives.
Wire number 1 on the cable is red or blue and the other wires are gray.
Connect one end to connector IDE1 or IDE2 on the single board com-
puter. Make sure that the red/blue wire corresponds to pin 1 on the con-
nector (in the upper right hand corner). See Chapter 1 for help finding the
connector.
Unlike floppy drives, IDE hard drives can connect in either position on
the cable. If you install two drives to a single connector, you will need to
set one as the master and the other as the slave. You do this by setting the
jumpers on the drives. If you use just one drive per connector, you should
set each drive as the master. See the documentation that came with your
drive for more information.
IDE2
IDE1